Does this ever happen to you?
You are weaving away on a wide inkle warp and it slips off a peg.
I have this affliction which causes me to design inkle warps that end up wider than I intended resulting in warp slippage.
This very wide warp has 132 10/2 perle cotton warp ends.
My solution? Rubber o-rings, also known as rubber jump rings.
The beauty of using rubber jump rings is that they are available in so many sizes and fun colors; plus they are fairly inexpensive. You can purchase them almost anywhere that sells jewelry making supplies. Or you can go to your local hardware store and get some rubber o-ring washers. I think they are in the plumbing section. Unfortunately, the ones at the hardware store only come in black, which is not nearly as fun!
Happy the day before Valentine’s Day. I revisited this post today after Liz Gipson a.k.a the Yarnworker, shared the project on her facebook page of the same name. Thank you, Liz! I am so glad she did. I haven’t seen these little hands and fingers in so long. They are still cute, in my unbiased mommy opinion, just 8 years bigger. Time does fly. In revisiting the post I made a few updates. The update is in two parts, so be sure to keep scrolling to the part 2.
Happy Valentine’s Day! Today is the perfect day for my first post since June; the perfect day to share that the reason for the break is the new love in my life. Growing this new love has kept me from weaving and writing, but ultimately has brought me so much joy. I am happy to introduce you to my new love, our new son, who joined us on January 10th.
My new love!
Now that I’m not “growing”’ this love anymore, I feel more like myself and am so happy to be weaving, writing and creating again. Although, arguably, I was creating for 9 months… So, here is an “inkle bit of love” project for you. I hope you enjoy.
Supplies needed: Craft glue, scissors.
You will need a band no wider than 3/4″ cut into four 8″ long pieces, any wider and it just looks wonky. However, shorter pieces will give you a smaller heart and longer pieces will give you bigger heart. (and the world needs more of those!) Use the glue to seal the edges of each band piece so they don’t fray and to glue the band ends down after you’ve gotten them into place.
Updated (2/13/21)
The Steps:
Interlace four ends of your cut bands, lining up the cut edges with the selvedges.
2. Fold the left vertical band over the top and under the bottom horizontal strips. Be sure not to twist when folding.
3. Fold the top horizontal band over, under, over the three vertical bands. Be sure not to twist when folding.
4. Fold the bottom horizontal band piece behind the center heart and glue in place. It is not woven in.
5. Repeat step 4 with the right vertical band.
Wouldn’t this heart be fun made into a lapel or scarf pin, a hair clip, a magnet… What else? Do you have any ideas?
Update part 2 (2/13/21):
Looking back on this post gave me the urge to make a pin. In my bin of bands that have no purpose but were fun to weave, I found a thinner 1/2″ band, in Valentine’s Day worthy colors. The heart is smaller than the original , about 3 1/2″ wide by 2 1/2″ tall.
The main difference from the original heart and this one, besides being smaller, is I bent the two outer bands back instead of over and back. The smaller size just seemed to call for it.
Then, I sewed a pin to a piece of felt cut to fit the back of the heart and glued the felt to the heart.
inkled pink 